Time-resolved cavity ringdown spectroscopy on nanoparticle generation in a SiH4–H2 VHF plasma

Time-resolved cavity ringdown (τ-CRD) spectroscopy has been applied to monitor the silyl (SiH₃) radicals and nanoparticles in a pulsed very high frequency (VHF) silane-hydrogen plasma under microcrystalline silicon (μc-Si:H) deposition conditions. The measured cavity loss reveals four time intervals (I up to VI) in the first 4 s of the plasma pulse. By variation of the laser wavelength, it is demonstrated that the small cavity loss at 220 nm reflects the SiH₃ absorption in interval I. In intervals II and III, an additional cavity loss appears. This additional cavity loss corresponds to Rayleigh and Mie scattering by growing nanoparticles. Interval IV reflects the loss of nanoparticles between the electrodes during the afterglow of the plasma pulse. The evolution of the nanoparticle generation determined from the τ-CRD measurements are further confirmed by additional scanning electron microscopy analyses on the nanoparticles created in the plasma pulse.     

Fine pore mouth structure of molecular sieve carbon with GCMC-assisted supercritical gas adsorption analysis

N₂ adsorption isotherms of molecular sieve carbon were measured at 77 K and 303 K. The Ar adsorption isotherms of molecular sieve carbon samples were also measured at 303 K. The grand canonical Monte Carlo (GCMC) simulation technique was applied to calculate the N₂ and Ar adsorption isotherms at 303 K using the ultramicropore volume determined by H₂O adsorption. The comparative method of experimental and simulated isotherms of supercritical N₂ and Ar at 303 K gave the width of the micropore mouth of the molecular sieve carbon, which can be applied to the ultramicropore width determination for other noncrystalline porous solids.     

Photochemical Behavior of Single‐Walled Carbon Nanotubes in the Presence of Propylamine

This report describes the photochemical behavior of single‐walled carbon nanotubes (SWNTs) in the presence of propylamine. The SWNTs are characterized by absorption and Raman spectroscopy. The spectral changes due to photoirradiation indicate that reactions occur predominantly with the metallic SWNTs and small‐diameter SWNTs. The detection of amine radicalcation species by ESR spectroscopy reveals photoinduced electron transfer from the amine to the excited SWNTs. After exposure of the photoirradiated SWNTs to air, the characteristic spectra were recovered, except for that of the small‐diameter SWNTs. The results suggest that, after photoreduction of the SWNTs, subsequent selective sidewall functionalization of the small‐diameter SWNTs occurs.     

Cyclic flow-injection analysis for the repetitive determination of zinc with 2-(5-bromo-2-pyridylazo)-5-[N-n-propyl-N-(3-sulfopropyl)amino]phenol and EDTA.

A circulatory flow-injection method (cyclic FIA) for the repetitive determination of zinc has been proposed. The procedure involves the use of 2-(5-bromo-2-pyridylazo)-5-[N-n-propyl-N-(3-sulfopropyl)amino]phenol (5-Br-PAPS) together with EDTA as a reagent carrier solution, which is recycled in a single-line flow system via a reservoir. The formed 5-Br-PAPS-Zn(II) complex was measured spectrophotometrically at 552 nm, and the signal intensity corresponded to the zinc concentration. After passing through a flow-through cell, the carrier stream then returned to the reservoir, and the main reagent, 5-Br-PAPS, was successfully regenerated by a ligand-exchange reaction with EDTA, allowing the repetitive determination of zinc. The calibration curve for zinc was linear in the concentration range from 0.4 to 10.0 mg dm(-3) with a correlation coefficient of 0.9995 (n = 6). The detection limit of this method was 0.02 mg dm(-3) (S/N= 3). This method allowed as many as 300 repetitive determinations of 2.0 mg dm(-3) zinc solution with only 100 cm3 of the circulating carrier solution, providing a reduction in the consumption of reagents and an elimination of waste, an important approach towards clean chemistry.     

Living cationic polymerization of 2‐adamantyl vinyl ether

Living cationic polymerization of 2‐adamantyl vinyl ether (2‐vinyloxytricyclo[3.3.1.1]^3,7decane; 2‐AdVE) was achieved with the CH₃CH(OiBu)OCOCH₃/ethylaluminum sesquichloride/ethyl acetate [CH₃CH(OiBu)OCOCH₃/Et_1.5AlCl_1.5/CH₃COOEt] initiating system in toluene at 0 °C. The number‐average molecular weights (M_n's) of the obtained poly(2‐AdVE)s increased in direct proportion to monomer conversion and produced the polymers with narrow molecular weight distributions (MWDs) (M_w/M_n = ～1.1). When a second monomer feed was added to the almost polymerized reaction mixture, the added monomer was completely consumed and the M_n's of the polymers showed a direct increase against conversion of the added monomer. Block and statistical copolymerization of 2‐AdVE with n‐butyl vinyl ether (CH₂?CH? O? CH₂ CH₂CH₂CH₃; NBVE) were possible via living process based on the same initiating system to give the corresponding copolymers with narrow MWDs. Grass transition temperature (T_g) and thermal decomposition temperature (T_d) of the poly(2‐AdVE) (e.g., M_n = 22,000, M_w/M_n = 1.17) were 178 and 323 °C, respectively. © 2008 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 46: 1629–1637, 2008     

Synthesis of endogenous sperm-activating and attracting factor isolated from ascidian Ciona intestinalis

A chemoattractant candidate named sperm-activating and attracting factor (SAAF) from the eggs of ascidian Ciona intestinalis, was synthesized from chenodeoxycholic acid in 16 steps. The present synthesis led to the unambiguous structure determination of SAAF to be (3R,4R,7R,25S)-3,4,7,26-tetrahydroxycholestane-3,26-disulfate. The synthetic pure specimen was also used to confirm the dual sperm-activating and attracting activity.     

Salvaging Reactive Fullerenes from Soot by Exohedral Derivatization

The awesome allotropy of carbon yields innumerable topologically possible cage structures of molecular carbon. This field is also related to endohedral metallofullerenes constructed by metal‐atom encapsulation. Stable and soluble empty fullerenes and endohedral metallofullerenes are available in pure form in macroscopic amounts from carbon arc production or other physical processes followed by extraction and subsequent chromatographic separation. However, many other unidentified fullerene species, which must be reactive and insoluble in their pristine forms, remain in soot. These “missing” species must have extremely small HOMO–LUMO gaps and may have unconventional cage structures. Recent progress in this field has demonstrated that reactive fullerenes can be salvaged by exohedral derivatization, which can stabilize the reactive carbon cages. This concept provides a means of preparing macroscopic amounts of unconventional fullerenes as their derivatives.